Mac Notification Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

MAC Notification Commands

The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table,
along with their appropriate parameters.
Command
enable mac_notification
disable mac_notification
config mac_notification
config mac_notification
ports
show mac_notification
show mac_notification
ports
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To enable MAC notification without changing basic configuration:
disable mac_notification
Purpose
Syntax
Description
Parameters
Parameters
{interval <int 1-2147483647> | historysize <int 1-500>
[<portlist> | all] [enable | disable]
<portlist>
Used to enable global MAC address table notification on the
Switch.
enable mac_notification
This command is used to enable MAC address notification without
changing configuration.
None.
Only administrator-level users can issue this command.
DES-3800:4#enable mac_notification
Command: enable mac_notification
Success.
DES-3800:4#
Used to disable global MAC address table notification on the Switch.
disable mac_notification
This command is used to disable MAC address notification without
changing configuration.
None.
253
38