Basic Ip Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

Basic IP Commands

The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config ipif
show ipif
enable autoconfig*
Each command is listed, in detail, in the following sections.
*See Switch Utility Commands for descriptions of all autoconfig commands.
config ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IP interface System:
Parameters
<ipif_name 12> [{ipaddress <network_address> |
vlan <vlan_name 32> |state [enable | disable]} bootp | dhcp]
{<ipif_name 12>}
Used to configure the System IP interface.
config ipif <ipif_name 12> [{ ipaddress <network_address> [ vlan
<vlan_name 32> | state [enable | disable]} | bootp | dhcp]
This command is used to configure the System IP interface on the
Switch.
<ipif_name 12> - Enter an alphanumeric string of up to 12 characters
to identify this IP interface.
ipaddress <network_address> − IP address and netmask of the IP
interface to be created. You can specify the address and mask
information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<vlan_name 32> − The name of the VLAN corresponding to the
System IP interface.
state [enable | disable] − Allows you to enable or disable the IP
interface.
bootp − Allows the selection of the BOOTP protocol for the
assignment of an IP address to the Switch's System IP interface.
dhcp − Allows the selection of the DHCP protocol for the assignment
of an IP address to the Switch's System IP interface. If you are using
the autoconfig feature, the Switch becomes a DHCP client
automatically so it is not necessary to change the ipif settings.
Only administrator-level users can issue this command.
127
18