Ip Multicasting Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

IP Multicasting Commands

The IP multicasting commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
show ipmc cache
show ipmc
Each command is listed, in detail, in the following sections.
show ipmc cache
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To display the current IP multicast forwarding cache:
DES-3800:4#show ipmc cache
Command: show ipmc cache
Multicast
Group
------------------
224.1.1.1
224.1.1.1
224.1.2.3
Total Entries: 3
DES-3800:4#
show ipmc
Purpose
Syntax
Parameters
{group <group>} {ipaddress <network_address>}
{ipif <ipif_name 12> | protocol [dvmrp|pim]}
Used to display the current IP multicast forwarding cache.
show ipmc cache {group <group>} {ipaddress
<network_address>}
This command will display the current IP multicast forwarding
cache.
group <group> − The multicast group IP address.
ipaddress <network_address> − The IP address and netmask of
the source. The address and mask information can be specified
using the traditional format (for example, 10.1.2.3/255.0.0.0 or in
CIDR format, 10.1.2.3/8).
None.
Source Address/Netmask Upstream
----------------
10.48.74.121/32
20.48.74.25 /32
10.48.75.3 /3
Used to display the IP multicast interface table.
show ipmc {ipif <ipif_name 12> | protocol [dvmrp|pim]}
Expire
Neighbor Time
--------------- ----------
10.48.75.63 30
20.48.75.25 20
10.48.76.6 30
230
35
Routing
Protocol
---------
dvmrp
dvmrp
dvmrp