Dns Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

DNS Commands

The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config dnsr
enable dnsr
disable dnsr
show dnsr
Each command is listed, in detail, in the following sections.
config dnsr
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To set IP address 10.43.21.12 of primary.
DES-3800:4#config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
Success
DES-3800:4#
Example Usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
Parameters
{[primary | secondary] nameserver <ipaddr> | [add | delete]
static <domain_name 32> <ipaddr>}
{cache | static}
{cache | static}
{static}
Used to configure the DNS relay function.
config dnsr {[primary | secondary] nameserver <ipaddr> |
[add | delete] static <domain_name 32> <ipaddr>}
This command is used to configure the DNS relay function on
the Switch.
primary − Indicates that the IP address below is the address of
the primary DNS server.
secondary − Indicates that the IP address below is the address
of the secondary DNS server.
nameserver <ipaddr> − The IP address of the DNS nameserver.
[add | delete] – Indicates whether to add or delete the DNS relay
function.
<domain_name 32> − The domain name of the entry.
<ipaddr> − The IP address of the entry.
Only administrator-level users can issue this command.
214
31