Traffic Segmentation Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

Traffic Segmentation Commands

Traffic segmentation allows you to further sub-divide VLANs into smaller groups of ports that will help
to reduce traffic on the VLAN. The VLAN rules take precedence, and then the traffic segmentation rules
are applied.
Command
config
traffic_segmentation
show
traffic_segmentation
Each command is listed, in detail, in the following sections.
config traffic_segmentation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ports 1 through 10 to be able to forward frames to port 11 through 15:
DES-3800:4# config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DES-3800:4#
show traffic_segmentation
Purpose
Parameters
[<portlist>] forward_list [null | <portlist>]
{<portlist>}
Used to configure traffic segmentation on the Switch.
config traffic_segmentation [<portlist>] forward_list [null |
<portlist>]
The config traffic_segmentation command is used to configure
traffic segmentation on the Switch.
<portlist> − Specifies a port or range of ports that will be configured
for traffic segmentation.
forward_list − Specifies a range of ports that will receive forwarded
frames from the ports specified in the portlist, above.
• null − No ports are specified
• <portlist> − Specifies a range of ports for the forwarding
list. This list must be on the same Switch previously
specified for traffic segmentation (i.e. following the
<portlist> specified above for config traffic_segmentation).
Only administrator-level users can issue this command.
Used to display the current traffic segmentation configuration on the
Switch.
185
25