Table of Contents
Advertisement
OPERATION
PASSIVE ARMING / PASSIVE LOCK MODES: (Programmable)
If programmed for passive (Automatic) Arming, the system will Arm itself 30 Seconds after the ignition is turned off and
the last door has been closed. The LED will begin flashing rapidly while counting down to Passively Arm. If a door is
open or reopened during the countdown, the system will wait (LED solid) for the door or zone to close before arming.
The unit will chirp once and flash the lights once. If Passive Locks are programmed ON, then doors will also lock.
Note: Passive Arming may qualify for insurance discounts-check with your agent or proprietor. The Passive
locking feature may increase the risk of locking the keys inside the vehicle.
AUTOLOCK/UNLOCK WITH IGNITION: (Programmable)
The doors will automatically lock when the ignition is turned on and will unlock when the ignition is turned off. If a door
is open the unit will not lock to prevent keys from being locked in.
ACTIVE RE-ARMING:
Active Re-arming allows the system to re-arm itself 30 seconds after it is disarmed with the transmitter in the event that
a door has not been opened. This is handy if the vehicle is accidentally disarmed without your knowledge (Remote is
pressed while in your pocket/purse). This feature can be turned off with the programming options.
DOME LIGHT ILLUMINATION: (Optional)
This feature turns on the vehicle's dome light upon disarm for 30 seconds or until the key is inserted and turned on.
This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security.
REMOTE START OPERATION
REMOTE ENGINE START:
Press and hold Button (II) on the transceiver for about 4 seconds until it beeps. The alarm will confirm your remote
start request by transmitting back to the remote transceiver with 3 beeps, engine icon and the word "START" on the
LCD screen. At the vehicle, the system chirps (3) times and the parking lights will turn on solid. After powering up the
Ignition and Accessory circuits, the unit will start the vehicle and run for 15 or 25 minutes (whichever is programmed).
Once the vehicle is running (in the first 8 seconds) the control module will page the remote with engine run status. The
LCD display will show a spinning engine icon, the words "ENGINE RUN", and an audible alert. If the vehicle fails to
start on the first attempt, the system will try up to (2) more times before aborting the remote start process.
REMOTE ENGINE STOP:
To stop (abort) a remote start, Press and hold Button (II) on the transceiver for about 4 seconds until it beeps. The
alarm will acknowledge the abort remote start request by transmitting back to the Remote. with (2) sets of 3 beeps.
The LCD Display will show a Key with slash and the Engine Run icon will flash (2) times and turn off. The will remain
Advertisement
Table of Contents
