Table of Contents
Advertisement
Control Module: Driver or Passenger side underdash, the unit should be placed as high as possible, not
easily accessible by an intruder.
Shock Sensor: Mount with wire ties to an under dash wire harness or fasten with screws to a panel.
Siren: Under the hood to fender-well or other body surface with the open end facing downward.
LED: In a visible location on the dashboard or console. Drill an 11/32" hole at the chosen location.
Override/Program button: Hidden location, but accessible to the user in case the system must be disarmed
without the use of the transmitter. This switch is also used to program certain features and to page/call the
transceiver from inside the vehicle if necessary.
Antenna Module: Inside front windshield (as high as possible) using supplied double sided tape.
6 PIN HI-CURRENT CONNECTORS:
RED:
RED:
BROWN:
YELLOW:
ORANGE:
PURPLE:
10 PIN MAIN HARNESS PLUG:
YELLOW WIRE: +12V BRAKE INPUT
Connect this wire to the side of the brake pedal switch that shows +12V only when the brake is depressed. This input
is used to reset remote start after entering the running vehicle and turning the ignition key on.
VIOLET WIRE: (+) DOOR TRIGGER INPUT
This wire is used for vehicles that show a positive voltage (12 volts) when the door is open such as Ford.
BLUE WIRE: (-) HOOD/TRUNK TRIGGER (Mandatory For Hood Pin)
Input trigger for a grounding hood or trunk pin switch and to inhibit remote start if the hood is open. Connect to
existing hood and trunk pin switches that read ground when open. If no existing switches are available, install a new
pin switch. Note: DO NOT mount new pin switches in water pathways.
SUGGESTED COMPONENT MOUNTING
WIRING
+12V INPUT
+12V INPUT (30 Amp)
IGNITION 1 (Secondary IGN. 1 Output)
IGNITION 1 (Primary IGN. Output AND Alarm Input for IGN "ON")
ACCESSORY (20 Amp)
STARTER OUTPUT
Advertisement
Table of Contents
