Table of Contents
Advertisement
Follow steps below to access Programming Options:
1. Turn the ignition on and press the override/program button 5 times within 5 seconds. You will hear a (2) Second
confirmation chirp from the siren.
2. Within the next 5 seconds press the override/program button [again] the number of times that corresponds to the
listed feature below. The siren will chirp once for each button press.
3. Once you are at the desired option number, press Button (I) or (II) on the remote to change the option. When
pressing button (II) you must hold it down 2-3 seconds until the remote beeps. Button (I) gives on light flash/chirp
and Button (II) give two flashes/chirps. See chart below for option selections. Turn OFF Ignition.
4. Change ONE option at a time and repeat steps 1-3 as needed.
Option # Option Description
1.
Passive Arming
2.
Passive Locks
3.
Active Re-Arm
4.
Silent Arm/Disarm
5.
Double Unlock Pulse
6.
Door Lock Pulse Time
7.
Ignition Controlled Locks
8.
Enable/Disable Cold Start
9.
Cold Start Interval Time
10.
Disarm with Aux. Feature
Activation (Trunk Pop)
11.
Chirp Countdown w/Passive
Arming
12.
Open Zone Warning
13.
Remote Start Run Time
14.
Doors Lock with Remote Start ON or OFF
15.
Lock After Aborted Remote
Start
16.
Parking Lights ON w/Disarm
1. PASSIVE ARMING
ON = Arming will occur 30 Seconds after the ignition is turned off and the last door has been closed. The LED will
flash rapidly during count down. OFF = System arming is controlled through remote only.
OPTION PROGRAMMING STEPS / CHART
Selection
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
0.7 Sec. or3 Sec.
ON or OFF
ON or OFF
Every 2 Hrs. or 1 hr.
ON or OFF
ON or OFF
10 or 60 Sec.
15 Min.or 25 Min.
ON or OFF
ON or OFF
Button (I)
Button (II)
ON
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
0.7 Sec.
3 Sec.
ON
OFF
OFF
ON
2 Hrs.
1 Hr.
OFF
ON
OFF
ON
10 Sec.
60 Sec.
15 Min.
25 Min
ON
OFF
ON
OFF
OFF
ON
Factory
Default
ON
ON
ON
OFF
OFF
0.7 Sec.
ON
OFF
2 Hrs.
OFF
OFF
10 Sec.
15 Min.
ON
ON
OFF
Advertisement
Table of Contents
