Table of Contents
Advertisement
You pull up to a convenience store for a quick stop, "Idle Down" mode keeps engine running when you exit
the vehicle, (with keys in hand) and arm the alarm. When you return, unlock/disarm alarm, turn ignition ON
and drive away.
Some Turbocharged vehicle manufacturers recommended that the driver leave the car at idle for a short
time after a long or vigorous drive before turning the car off. This allows the turbo to cool down.
With engine running, press and hold the brake pedal and push button (I) on the Transmitter. The parking
lights/remote start will turn ON. Turn Off the Ignition and remove key while engine will remains running. Exit
vehicle and arm the system. The Engine will remain running for programmed run time, until you return, or it can
be turned off at any time through Button (II).
SELF-START MODE: (Programmable)
The vehicle can be programmed to start every 1 or 2 hours automatically during extreme weather conditions.
DO NOT leave vehicle in a closed garage with this feature activated! First make sure the self-start mode
has been enabled with program option #8. (Unit starts every 2 hours by default). Use program option #9 to
change interval time if needed. To start self-starting mode, press and hold the brake pedal and the Valet
button, then Button (II) on the transceiver for about a second. The parking lights will flash 5 times, and the
vehicle will automatically start and run for about 30 seconds then turn off by itself. From this point on, as long
as you don not press the brake pedal or the Remote Start button on the Transmitter, the vehicle will start by
itself after the pre-programmed time period (1 or 2 hours). Vehicle will self-start a maximum of 12 times.
After that, you will need to go through the brake/override/button (II) procedure again.
ANTI-GRIND / STARTER DISABLE (Optional)
Prevents the user from accidentally grinding the starter if the Ignition key is turned too far to the start position while
engine is already running from the remote starter. Starter circuit is automatically disabled when alarm is armed to
protect the vehicle from "Hot Wiring".
HOOD OPEN & BRAKE PEDAL SAFETY CIRCUITRY
Both the hood pin and brake switch will prevent the engine from being remote started. Both circuits will also cause a
remote started engine to shut down if activated while running. This helps eliminate the risk of injury to someone
working under the hood or tampering of the vehicle. If a Remote start is requested with the hood/brake active, the
lights will flash twice and the unit will not attempt a start.
REMOTE START OPERATION
**IMPORTANT NOTES**
Advertisement
Table of Contents
