Power Management Setup - ECS PM800-M2 Manual

Power Management Setup

This option lets you control system power management. The system has various power-
saving modes including powering down the hard disk, turning off the video, suspending to
RAM, and software power down that allows the system to be automatically resumed by
certain events.
The power-saving modes can be controlled by timeouts. If the system is inactive for a time,
the timeouts begin counting. If the inactivity continues so that the timeout period elapses,
the system enters a power-saving mode. If any item in the list of Reload Global Timer
Events is Enabled, then any activity on that item will reset the timeout counters to zero.
If the system is suspended or has been powered down by software, it can be resumed by a
wake up call that is generated by incoming traffic to a modem, a LAN card, a PCI card,
or a fixed alarm on the system realtime clock.
HDD Power Down
Suspend Mode
Video Off Option
Video Off Method
MODEM Use IRQ
Soft-Off by PWRBTN
Ac Loss Auto Restart
!
IRQ/Event Activity Detect
"#$%
: Move
F5:Previous Values
HDD Power Down (Disable)
The IDE hard drive will spin down if it is not accessed within a specified length of time.
Options are from 1 Min to 15 Min and Disable.
Suspend Mode (Disable)
After the selected period of system inactivity, all devices except the CPU shut off.
Video Off Option (Suspend-> Off)
This option defines if the video is powered down when the system is put into suspend mode.
Video Off Method (DPMS Support)
This item defines how the video is powered down to save power.
MODEM Use IRQ (3)
If you want an incoming call on a modem to automatically resume the system from a power-
saving mode, use this item to specify the interrupt request line (IRQ) that is used by the
modem. You might have to connect the fax/modem to the motherboard Wake On Modem
connector for this feature to work.
Phoenix-AwardBIOS CMOS Setup Utility
Power Management Setup
[Disable]
[Disable]
[Suspend-> Off]
[DPMS Support]
[3]
[Instant-Off]
[Off]
[Press Enter]
Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F6:Fail-Safe Defaults
Using BIOS
Item Help
!
Menu Level
F7:Optimized Defaults
39