Recommended Cleaning; Preparation For Use - Crestron CT-3500 Operation Manual

CRESTRON

Recommended Cleaning

Keep the surface of the touchscreen free of dirt, dust, or other materials that could
degrade optical properties. Long term contact with abrasive materials can scratch
the surface which may detrimentally affect image quality.
For best cleaning results, use a clean, damp, non-abrasive cloth with any
commercially available non-ammonia glass cleaner. Bezels may not provide a
complete water-tight seal. Therefore, apply cleaning solution to the cloth rather
than the surface of the touchscreen. Wipe touchscreen clean and avoid ingress of
moisture beneath panels.

Preparation for Use

The only preparation that may be required is to mount the touchpanel. If a CT-
3500L or VT-3500L is being installed, the cutout dimensions are required. Refer to
the lectern cutout details below for these configurations. Cutout measurements in
the figure have been rounded up to the nearest 1/8 inch.
CT/VT-3500L Lectern Cutout Detail
If a CT-3500 or VT-3500 is being mounted to a flat surface, locate the mounting
holes on the "foot" of the touchpanel. Refer to the mounting information below for
these configurations. Mount the touchpanel with #6-32 hardware (not supplied).
CT/VT-3500 Mounting Detail
8 Series 3500 Touchpanels Operations Guide - DOC. 8108B