Programming; Reserved Join Numbers - Crestron CT-3500 Operation Manual

Programming

Operations Guide - DOC. 8108B
CRESTRON
paragraph. The RS-232 Menu specifies four parameters required for the touchpanel
to use its RS-232 serial port. Ten baud rate buttons, labeled 110, 150, 300, 600,
1200, 2400, 4800, 9600, 19200, and 38400, are available for selection. Also select
seven or eight data bits; none, odd, or even parity; one or two stop bits. Selections
for each of the four parameters are indicated with red text. The parameters are
factory set to 38.4 Kbd, eight data bits, no parity bits, and one stop bit.
RS-232 Menu
Select the Return to Previous Menu button, located at the bottom of the RS-232
Menu, after RS-232 parameters have been set.
Save Setup and Run Program
The Save Setup and Run Program button, located at the upper right corner of the
Main Menu, saves all of the setup information to EEPROM and displays the main
page that has been programmed into your system.

Reserved Join Numbers

A reserved join number is a feature of the software that enables a designer to create
a button on a page that either calls up the Setup Menu, ramps brightness, etc. The
tables below provide a list of reserved join numbers available within the software.
Reserved Join Numbers for Series 3500 Touchpanels
JOIN NUMBER
1016
1017
1018
1019
1035
1093*
1094*
1095*
1096*
1097*
1098*
1099*
(Refer to the next table for analog join numbers.)
* Applies to VideoTouch configurations only.
FUNCTION
Brightness
Brightness
Brightness
Brightness
Call up Setup Menu
Composite Video Mode
S-Video Mode
Fast Motion Mode
Still Video Mode
Soft Mode
Sharp Mode
Set Video Adjustments to 50%
Series 3500 Touchpanels
VALUE
Off
Low
Medium
High
Not Applicable
Not Applicable
Not Applicable
Not Applicable
Not Applicable
Not Applicable
Not Applicable
Not Applicable
15