Configuring The Touchpanel - Crestron CT-3500 Operation Manual

Operations Guide - DOC. 8108B
CRESTRON
loaded panel page. To enter SETUP MODE and not RUN MODE,
hold a finger to the touchscreen as power is applied. The user may
configure the unit while in SETUP MODE.

Configuring the Touchpanel

To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the touchpanel for normal operation.
The Main Menu for configuring the touchpanel appears when a finger is held to the
touchscreen as power is applied. Remove your finger when the message "SETUP
MODE" appears on the touchscreen. Holding a finger to the touchscreen for five
seconds after the "SETUP MODE" message is displayed sets the brightness to high.
Upon entering SETUP MODE, the Main Screen, shown below, displays four
buttons: TOUCH SCREEN CALIBRATION, DIAGNOSTICS, SETUP, and SAVE
SETUP AND RUN PROGRAM.
Main Menu
Calibration Menu
Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button's image. Select the TOUCH SCREEN CALIBRATION
button to display the Calibration Menu, shown below. The Calibration Menu offers
the choice to initiate calibration with the Perform Calibration button or return to the
previous screen with the Return to Main Menu button. Choose an option by
touching the correct button. When touching the screen, be as accurate as possible. If
you proceed to calibrate the touchpanel, the screen prompts you with the message
"Touch Screen Calibration Menu" nearly centered on the display. Another message,
"Touch Upper Left Corner", appears in the upper left corner. Touch the corner of
the screen to initiate calibration. Another message, "Touch Lower Right Corner",
appears in the lower right corner. Touch the corner of the screen to return to the
Main Menu.
Calibration Menu
Series 3500 Touchpanels 11