Physical Description - Crestron CT-3500 Operation Manual

CRESTRON
position lock button can be depressed with one hand; the touchscreen can be tilted
down to the horizontal position with the other, shown below.
Hand Position for Tilting Touchpanel to Horizontal

Physical Description

Touchpanels
The 10.4 inch (26.4 cm) touch sensitive viewing screen is located on the front of
each Series 3500 Touchpanel. The electronic hardware is housed in a high impact,
black molded plastic enclosure for the adjustable tiltcase configurations, shown
below. These two touchpanels are designed to be placed on a counter and possess a
hinged base which can tilt from 0 to 70 degrees. Depress the button located at the
front of the base when pivoting the touchpanel to the horizontal position. A 6-pin,
6-position RJ11 modular jack is located at the rear of the CT-3500's base. Use the
cable assembly (supplied) to connect the touchpanel to the CN-RJ11 (supplied),
which attaches directly to the CRESNET II network. The VT-3500 has an 8-
position, 8-pin modular telephone jack on the base. A supplied 11 to 12 foot
network cable with 8-position, 8-pin connectors on each end connects the panel to
the VT-3500IMC (supplied) or VT-3500IMW (purchased separately). Each
VideoTouch interface module has video connectors and a 4-pin network connector
for attachment to the CRESNET II network.
Physical Views of CT- and VT-3500 (CN-RJ11 and VT-3500IMC not shown)
The CT-3500L and VT-3500L, shown after this paragraph, are housed in a black
metal box topped with a plastic cover. These units are designed for lectern mount.
The 15-pin VGA OUT, four-pin network, nine-pin RS-232, and two coaxial cable
ports are located on the rear of the panel. The coaxial cable ports are only available
on the VT-3500L.
Operations Guide - DOC. 8108B Series 3500 Touchpanels 3