Wireless Access Point Configuration - Cisco FM1200 Installation And Configuration Manual

Encryption, DES
(Advanced Encryption Standard).
6. To change the current encryption pass phrase, enter a
new pass phrase in the SNMP v3 encryption pass phrase:
field. Thedefault encryption pass phrase is cisco. To
show the pass phrase as it is being typed, check the Show
SNMP v3encryption pass phrase: check-box.
7. SNMP traps can be enabled for significant system-related events.
If needed, enable SNMP event traps by checking the Enable
SNMP event trap: check-box, and enter the name of the network
management station (NMS) host in the NMS hostname: field.
8. You can also configure the unit to send SNMP traps at defined
periodic intervals. If needed, enable periodic SNMP traps by
checking the Enable SNMP periodic trap: check-box, and enter
the name of the network management station (NMS) host in the
NMS hostname: field.
9. Save the SNMP settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.

7.6.6. Wireless access point configuration

All FM1200 Volo, Cisco 3200-series and Cisco 4200-series radio
transceivers equipped with firmware version 6.5 and above have a built-in
wireless access point (AP).
This wireless AP is intended for use by the network's service and
maintenance personnel. If the AP is enabled, you can easily connect to
the transceiver unit from a short distance away, using a laptop computer
or any other Wi-Fi-enabled device.
Note that the radio unit can be configured as a wireless access point (AP)
or as a wireless station (STA).
IMPORTANT
To minimize impact on overall system performance, wireless
AP bandwidth is limited to 5 Mb/s. This is sufficient for
maintenance purposes, but is not sufficient to support normal
wireless carrier operations.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
(Data Encryption
IMPORTANT
The same encryption protocol must be set for all
Cisco units in the wireless network.
IMPORTANT
The NMS host to which traps are sent must have an
SNMP agent configured to collect v2c traps.
Standard) and AES
Page 108 of 175