Rules For Packet Management - Cisco FM1200 Installation And Configuration Manual

Figure 49. Configurator GUI (VLAN SETTINGS dialog)
2. Connect the unit to a VLAN that is part of the local wireless
network by checking the Enable VLANs check-box.
3. Check the
4. Enter the management identification number of the VLAN (used
to communicate with the device's operating system) in the
Management VLAN ID: field.
5. Enter the native identification number (the VLAN ID implicitly
assigned to untagged packets received on trunk ports) in the
Native VLAN ID: field.
6. Save the VLAN settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.

Rules for packet management

Parameter
Default VLAN configuration
The factory-set VLAN parameters for the unit are as follows:
Management VLAN ID (MVID)
Native VLAN ID (NVID)
Native VLAN processing
Port mode (all Ethernet ports)
Traffic classes
The system classifies incoming data packets according to the following definitions:
Signaling
User
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Enable VLANs check-box.
NOTE
The same Management VLAN ID must be used on all
Cisco devices that are part of the same mesh
network.
1
1
Enabled
Smart
Ethernet protocol type $8847 or $09xx
All other traffic
Default value
Page 119 of 175