Pass Lists And Block Lists - Cisco FM1200 Installation And Configuration Manual

• The Static Routes dialog will be shown
Figure 35. Configurator GUI (Static Routes window)
To enter a new static route, do the following steps:
1. Enter the Subnet, Netmask and Gateway designators in the
correct fields of the Add new static route section.
2. Click the
• If the new static route is valid, it will be added to the Active
static routes list.

7.6.3. Pass lists and Block lists

IMPORTANT
The Pass list or Block list feature is only available if the Cisco
FM1200 Volo is set to Mesh Point mode or Mesh End mode
mode. If the unit is set to Bridge mode, the –pass list / block
list menu option will not be available.
The Pass list or Block list function is a security feature that prevents fake
IP addresses from intercepting or intruding on the network.
A Pass list is a group of Cisco transceivers, described as a list of
linked pairs. Within the list, each transceiver unit is considered a valid hop
in the routing table. If a Pass list is created, all transceiver units that are
not on the Pass list are excluded from packet routing.
Conversely, a Block list is a group of Cisco transceivers that are
excluded by the routing table computation, and to which data packets
must not be routed. If a Block list is created, all transceiver units that are
on the Block list are excluded from packet routing.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
add button.
(Figure 35 (page 97)).
Page 97 of 175