Supplying Power To The Cisco Fm1200 Volo - Cisco FM1200 Installation And Configuration Manual

5.1.4. Supplying power to the Cisco FM1200 Volo

CAUTION
When connecting the Cisco FM1200 Volo to a power supply,
be sure to follow the instructions in this section at all times.
Failure to follow these instructions may result in irreparable
damage to the unit and/or other connected hardware, and will
also invalidate the product warranty.
IMPORTANT
For technical data on which power sources are compatible with
the
requirements" (page
The Cisco FM1200 Volo can be provided with power using the following
methods:
• The included 24 Vdc passive PoE injector (90 Vac to 260 Vac,
50/60 Hz input).
• If connecting the unit to an Ethernet switch or router equipped with
unmanaged PoE, an IEEE 802.3af-to-24 Vdc inline converter
(model number FM-POE-INL).
CAUTION
The Cisco FM1200 Volo is designed to accept power from the
included 24 Vdc mode B passive PoE injector (model number
FM-POE-STD) or from an IEEE 802.3af-to-24 Vdc inline
converter (model number FM-POE-INL) only. Do not connect
power supplies of any other voltage output, type or rating to the
unit under any circumstances.
Do not connect an unmanaged PoE switch (in other words, a
PoE switch on which DC power to the RJ45 ports cannot be
switched off) to the Cisco FM1200 Volo under any
circumstances. Connecting an unmanaged PoE switch to the
unit will result in 48 Vdc power being supplied to the unit. This
will irreparably damage the unit, and will invalidate the product
warranty.
When providing the power source for the Cisco FM1200 Volo, remember
the following important points:
• Install the power source as close to the unit as possible to minimize
voltage drop. The maximum suggested distance is 50ft (15m).
• Ensure proper grounding (earthing) and reliable connectivity by
using shielded CAT5/6 cables and connectors.
• If you are connecting the Cisco FM1200 Volo directly to a power
source, only use the included 24 Vdc mode B passive PoE
© 2021 Cisco and/or its affiliates. All rights reserved.
Cisco FM1200 Volo,
158).
Hardware installation
refer to "Electrical power
Page 31 of 175