Table of Contents
Advertisement
Repair
Accelerometer Replacement
Table
1. Disconnect power to the unit. See Power Discon-
nect, page 18.
2. Remove screws (3) and display panel (11). See
Display (Keypad) Replacement, page 22.
3. Disconnect sensor wires (69) from table control
board (80).
4. Loosen strain relief and remove wire from control
panel area.
ti22025a
24
5. Loosen wire clamp and pull wire through pedestal.
Remove wire from corrugated sleeving.
6. Remove screws (19) holding accelerometer (69) to
table mounting bar (27).
27
7. Replace accelerometer (69), tighten screws (19) to
25-30 in-lb.
8. Ensure wire is routed in protective sleeving through
strain relief.
9. Replace wire clamps.
10. Attach wire to control board.
11. Tighten strain relief.
ti22038a
12. Replace display panel and screws.
ti22032a
69
19
ti22033a
332462E
Advertisement
Table of Contents
