Table of Contents
Advertisement
When the temperature reaches 95°C, humidity control must be switched off, so a very short
segment (9) has to be carried out that lasts only a few seconds (e.g. 5 secs.)
9 (°C)
To set segment
9 (% RH)
To set segment
SHIFT
ENTER
This page is visualized
• Press repeatedly
WARNING!
If you have accidentally saved the same segment twice, correct the number on this page.
Temperature 95°C
Duration 5 secs - Maintenance
hh : mm : ss
Durat.
0 : 0 : 5
Wait duration
Channel 1
Control
Wait set point
Max speed
: 95.00 °C
Set point
: 0.00 °C/min
Grad.
Near set
Humidity 95% (switch off humidity)
Channel 2
Control
Wait set point
Max speed
Set point
: 95.00 RH %
Grad.
: 0.00 RH %/min
Near set
: 3,00 RH %
Water recharge:
Not used:
Not used:
SP. hum. CTRL.
Save segment
Save segment
Total segment
Confirm progr
EDIT PROGRAM
< ESC > Prev. menu
Segment N. 10
M1
: ON
M2
: ON
: OFF
: OFF
M3
: 1,00 °C
M4
: OFF
: OFF
: OFF
M5
M6
OFF
OFF
OFF
ON
M7
: SAVE
: OFF
: 0
: OFF
M8
Wait for this number to appear.
30
95
30
Because the same temperature value
is maintained
Because the same temperature value
is maintained
To switch off humidity control
This data as well as the following data
will be ignored as the humidity control
has been switched off.
to save the programmed segment
When this page is visualized, if the
previously described operations have
been carried out, the segment has
been saved and therefore must not be
saved again.
Move on to the next step.
9
Hide quick links:
Advertisement
Table of Contents
