How To Set A Programme - Siemens SIMATIC OP7 Manual

4.3

HOW TO SET A PROGRAMME

The cycle shown in the graph will be set as an example here below.
• Place the software alarms into position (paragraph 2.5)
• Place the hardware alarms into position (see machine handbook)
KEYS
K3
1
ENTER
To select option 1
"Edita programme"
DISPLAY
Cycles menu
Program edit
Loop table
Save program
Load program
Delete program
Repetition
Ver. curr. progr.
Choice
Start progr.
Monitoring
EDIT PROGRAM
< ESC > Prev.menu
Segment N. 1
Durat.
Wait duration
Channel 1
Control
Wait set point
Max speed
When segment switch ON, it must be
carry at the maximum speed
B1
B2
: (1)
: (2)
: (3)
: (4)
B3
: (5)
: (6)
: (7)
B4
#
STOP
: OFF
B5
B6
hh : mm : ss
0 : 0 : 0
: OFF
there are two channels for each segment:
Channel 1: to set the temperature
B7
Channel 2: to set the humidity
when it is switched ON, temperature control is
: OFF
enabled
: OFF
when it is switched ON, it moves on to the next
: OFF segment only when the set set point is reached.
When it is switched OFF, it moves on to the
next segment after the set time, whether the
set value has been reached or not.
20
FUNCTIONS
This page is used to select the various
functions to run the cycles and to start
or stop a programme.
to set a programme
to set a loop (§4.4)
to save a programme (§4.5)
to load a programme into the memory
(§4.6)
to delete a programme already memo-
rized (§4.7)
to define the number of times a pro-
gramme has to be repeated (§4.8)
to visualize a set cycle (§4.9)
to select a function (from 1 to 7)
to start or stop a programme
when it is switched ON, the current seg-
ment is visualized only while the cycle is
being carried out
The temperature values and other pa-
rameters are set on this page
These data must not be set for the first
segment;
The first segment must be carried out at
maximum speed.