Table of Contents
Advertisement
CS Cabinet Range
Repeat procedures until all cabinets are aligned.
8.
Apply finishing sealants and any jointer items. Remove masking tape from sealed joins. Tidying
9.
up any excess sealant.
Check all glass gaps. Adjust as required to have an even gap between each glass.
10.
After all services have been installed and completed, fit coving angles and dress panels.
11.
Clean the condensate deck of any filings and rubbish that may have accumulated during
12.
installation. These may block drains or cause rust damage to panels over time.
Fit any internal panels that have been removed for installation.
13.
14. Fit all supplied accessories. A list of separately wrapped loose items should be in the cabinet
Fitting End Walls
1. Apply a suitable flexible sealant to the cabinet between the refrigerated area and the ambient
environment.
2. Apply masking tape to the cabinet where a tidy finish is required for the finishing sealant once
the end is fitted.
3. Hold the end against the cabinet and insert the fixing bolts supplied. Do not completely tighten.
4. Align the end with the cabinet so the end trim is parallel with adjacent panels on the cabinet.
Fully tighten the fixing bolts.
5. Apply sealant to neatly finish the join between cabinet and end.
Adjusting Front Glass
Due to the need to have a robust arm support system, the front glass should not require adjustment
when the cabinets are installed level from front to back and end to end. If there are any issues with glass
alignment the problem may lay elsewhere. In this instance, contact Hussmann notified for assistance.
Replacement Gas Struts
Replacement gas struts are available from Hussmann along with fitting instructions for the cabinet type.
Please supply serial number of the cabinet to ensure correct replacement parts
When working on gas struts or any of the glass hardware, 2 people are
required to make this a safe operation.
CAUTION
/ŶƐƚĂů ů ĂƟŽŶ D ĂŶƵĂů
24
Advertisement
Table of Contents
