Using The Console; Connecting To Your Switch With Hyperterminal - Cisco Linksys SGE2010P Admin Manual

48-port 10/100/1000 ethernet switch business series
Hide thumbs Also See for Linksys SGE2010P:
Table of Contents

Advertisement

4

Using the Console

This chapter describes the use of the switch console, which allows you to perform basic
configuration of the switch.
The switch features a menu-driven console interface for basic configuration of the switch and
management of your network.This chapter describes console interface configuration.
Configuration can also be performed through the web utility, which is covered in the next
chapter.
"Connecting to Your Switch with HyperTerminal, " on page 9
"Connecting to the Switch with Telnet, " on page 12
Logging On to the Console (see page 12)
Selecting Menu Options and Actions (see page 12)
Using the Switch Main Menu (see page 13)
System Configuration (see page 13)
Port Status (see page 44)
Port Configuration (see page 46)
System Mode (Layer 2 / Layer 3) Selection (see page 48)
Help (see page 49)
Logout (see page 50)

Connecting to Your Switch with HyperTerminal

You can use the HyperTerminal to connect to your switch.
NOTE: The switch also can be configured through a telnet connection. Telnet to the switch IP
address 192.168.1.254. Then, press the Enter key. The default logon ID is admin with a blank
password.
Before you use HyperTerminal to connect to your switch for the first time, you must configure
the application on your PC. You can save the settings to use each time you connect to your
switch.
SGE2010/SGE2010P Administration Guide
Using the Console
Connecting to Your Switch with HyperTerminal
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Linksys sge2010

Table of Contents