Connecting A Terminal Or Pc To The Console Port; Connecting To Dc Power - Cisco 809 Hardware Installation Manual

Industrial integrated services router

Hide thumbs Also See for 809:

Table of Contents

Connecting a Terminal or PC to the Console Port

The Cisco 809 ISR does not provide the standard Cisco RJ45 RS232 serial port for Console. Instead, a USB

Console port with a mini-Type B connector is provided. Connect a terminal or PC to the Console port either

to configure the software by using the CLI or to troubleshoot problems with the router.

To connect a terminal or PC to the Console port on the router and access the CLI, follow these steps:

Before you begin

Before you connect the router to the devices, install the router according to the instructions in

Router, on page

Step 1

Connect the mini-USB side of a cable to the USB Console port on the router. The following figure shows the mini-USB

location (1) for the Console port on the router.

Step 2

Connect the opposite end of the mini type B USB cable to the USB port on your laptop or PC.

Step 3

To communicate with the router, wait for your laptop or PC to discover the new device.

Step 4

If your laptop or PC warns you that you do not have the proper drivers to communicate with the router, you can obtain

them from your computers manufacturer, or go here:

Step 5

Run a Terminal Emulation App (such as Tera Term) from the PC. Select the "standard" serial Com Port (from the standard

or enhanced options), and configure it for 9600 Baud rate with no flow control

Warning

This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the

protective device is rated not greater than 10A Statement 1005

Cisco 809 Industrial Integrated Services Router Hardware Installation Guide

19.

https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers

Connecting the Router

Installing the

Table of Contents

Ir809g-lte-la-k9