Cisco Linksys SGE2010P Admin Manual page 34

Using the Console
System Configuration
IPv6 Address Table
The IPv6 Address Table lists the IPv6 addresses that are configured.
To open this screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 2. IPv6 Address Configuration.
4. From the IPv6 Address Configuration menu, select 3. IPv6 Address Table.
IPv6 ISATAP Enable
You can use the IPv6 ISATAP Enable screen to configure the ISATAP tunnel.
To open this screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 2. IPv6 Address Configuration.
4. From the IPv6 Address Configuration menu, select 4. IPv6 ISATAP Enable.
SGE2010/SGE2010P Administration Guide 31