Sge2010/P Back Panel - Cisco Linksys SGE2010P Admin Manual

48-port 10/100/1000 ethernet switch business series
Hide thumbs Also See for Linksys SGE2010P:
Table of Contents

Advertisement

Feature
Description
1-48
The Switch is equipped with 48 auto-sensing, Ethernet (802.3) network
ports, which use RJ-45 connectors. The Fast Ethernet ports support
network speeds of 10Mbps, 100Mbps, or 1000Mbps. They can operate in
half and full-duplex modes. Auto-sensing technology enables each port to
automatically detect the speed of the device connected to it, and adjust
its speed and duplex accordingly.
The switch can deliver a maximum of 15.4W to a PoE port. With regular AC
power supply, there is 360W available to all PoE ports, and 280W available
with redundant power supply.
Ports 45, 46, 47 and 48 are shared with miniGBIC1, miniGBIC2, miniGBIC3,
and miniGBIC4, respectively.
NOTE: A switch is in stacking mode by default. In stacking mode, ports 24
and 48 are reserved for use as stacking ports. For more information
about stacking, refer to the SFE2010/SGE2010 Reference Guide.
miniGBIC1-4
The switch provides four mini-GBIC ports. The mini-GBIC (gigabit interface
converter) port is a connection point for a mini-GBIC expansion module,
so the Switch can be uplinked via fiber to another switch. Each mini-GBIC
port provides a link to a high-speed network segment or individual
workstation at speeds of up to 1000Mbps.
Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules with the
switch. The MGBSX1 and the MGBLH1 require fiber cabling with LC
connectors, while the MGBT1 requires a Category 5e Ethernet cable with
an RJ-45 connector.
NOTE: If shared ports are both connected, then the miniGBIC port has
priority.

SGE2010/P Back Panel

Feature
Description
Power
The Power port is where you will connect the power cord.
Console
The Console port is where you can connect a serial cable to a PC's serial
port for configuration using your PC's HyperTerminal program. Refer to
Chapter 4: Using the Console Interface for Configuration for more
information.
RPS
Redundant Power Supply (Linksys RPS1000)
SGE2010/SGE2010P Administration Guide
Getting to Know the SGE2010/SGE2010P
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Linksys sge2010

Table of Contents