User Manual of Explosion-Proof PTZ Camera
You can use SNMP to get Explosion-Proof PTZ Camera status and parameters related
information.
Before you start:
Before setting the SNMP, use the SNMP software and manage to receive the Explosion-Proof PTZ
Camera information via SNMP port. By setting the Trap Address, the Explosion-Proof PTZ Camera
can send the alarm event and exception messages to the surveillance center.
The SNMP version you select should be the same as that of the SNMP software.
Steps:
1. Enter the SNMP settings interface:
Configuration > Network > Advanced Settings > SNMP
2. Check the corresponding version checkbox (Enable SNMP v1, Enable SNMP v2c, Enable
SNMP v3) to enable the feature.
3. Configure the SNMP settings.
Figure 6-7 SNMP Settings
68