Starting Therapy; Stopping Therapy; Power Save Mode - ResMed AirStart 10 APAP User Manual

Starting therapy

1. Fit your mask.
2. Press Start/Stop.
You will know that therapy is on when the Sleep Report screen is displayed.
The screen will go black automatically after a short period of time. You can press Home or the dial to
turn it back on. If power is interrupted during therapy, the device will automatically restart therapy
when power is restored.

Stopping therapy

1. Remove your mask.
2. Press Start/Stop.
The Sleep Report now gives you a summary of your therapy session.
Humidifier–Indicates if your humidifier is working properly:
Humidifier working.
Humidifier might be faulty, contact your care provider.

Power save mode

Your AirStart 10 device records your therapy data. However, you can put it into power save mode to
save electricity.
To enter power save mode:
• Press and hold Start/Stop for three seconds.
The screen goes black.
To exit power save mode:
• Press Start/Stop once.
The Home screen is displayed.
The current treatment pressure is shown in the centre of the screen.
During ramp time the pressure is gradually increasing and you will see a
spinning circle. Once the prescribed treatment pressure is reached, the entire
circle will be solid.
Usage hours–Indicates the number of hours of therapy you received last
session.
Mask Seal–Indicates how well your mask sealed:
Good mask seal.
Needs adjusting, see Mask Fit.
English 5