Installing The Processor And Heat Sink Module - Dell EMC PowerEdge XR11 Installation And Service Manual

Abbildung 56. Setzen des Kühlkörpers auf den Prozessor ein
Nächste Schritte
1. Setzen Sie den Kühlkörper wieder
2. Bringen Sie das Prozessorkühlgehäuse wieder
3. Befolgen Sie die Anweisungen unter

Installing the processor and heat sink module

Prerequisites
Never remove the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the processor air
NOTE: The procedure to install the heat sink is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Set the anti-tilt wires to the unlocked position on the heat sink (inward position).
2. Align the pin 1 indicator of the heat sink to the system board, and then place the processor and heat sink on the processor
socket.
CAUTION: To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE: Ensure that the processor and heat sink is held parallel to the system board to prevent damaging the
components.
ein.
an.
Nach der Arbeit im Inneren des
Safety instructions.
Vor der Arbeit an Komponenten im Inneren Ihres
shroud.
Systems.
Systems.
Installieren und Entfernen von Systemkomponenten 67