Installing The Drive Into The Drive Carrier - Dell EMC PowerEdge XR11 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge XR11:
- Installation and service manual (124 pages) ,
- Installation and service manual (124 pages)
Table of Contents
Advertisement
Available languages
Available languages
Figure 35. Removing the drive from the drive carrier
Next steps
Replace the drive into the drive
carrier.
Installing the drive into the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips 1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE:
If the drive carrier has Torx screw
, use Torx 6 (for 2.5-inch drive).
Installieren und Entfernen von Systemkomponenten
47
Advertisement
Table of Contents
