Installing The Bezel Filter For Rear Accessed Configuration - Dell EMC PowerEdge XR11 Installation And Service Manual

Figure 17. Removing the front bezel filter for Rear Accessed configuration
2. Remove the filter below the metal bracket.
NOTE: To maintain optimal system health, Dell Technologies recommends checking and changing the filter every three
months. Filters can be ordered from Dell.
Next steps
Replace the bezel filter.

Installing the bezel filter for Rear Accessed configuration

Prerequisites
1. Follow the safety guidelines listed in the
2. Remove the front bezel.
Steps
1. Place the new filter in the bezel cavity under the filter bracket. Ensure that the filter is smooth and aligned in the allowed
slot.
2. Align the filter bracket with painted surface facing the filter and align the bracket to the guides on the bezel.
3. Place the bracket on the bezel for the magnets to secure in place.
32 Installieren und Entfernen von Systemkomponenten
Safety instructions.