Canon MultiPASS F20 Software User's Manual page 122

The Microsoft Network Client is not installed. Follow this procedure:
1. On the Windows desktop, click [Start], point to [Settings], then
2. In the Control Panel window, double-click [Network].
3. On the Configuration tab, check whether "Client for Microsoft
4. In the Select Network Component Type dialog box, click Client,
5. In the Select Network Client dialog box, click [Microsoft] and
6. In the Network dialog box, click OK.
7. Restart your PC.
8. Reinstall the MultiPASS Suite (Setup Sheet).
During installation, you were prompted to connect a USB
cable, and you could not proceed further.
Remove the device from the Device Manager as follows:
1. In the dialog box prompting you to connect a USB cable, click No and
exit installation of the MultiPASS Suite.
2. On the Windows desktop, click Start, point to Settings, then click
Control Panel. (Windows XP: On the Windows desktop, click Start,
then Control Panel.)
3. In the Control Panel window, double-click System. (Windows XP:
Click Performance and Maintenance, then System.)
4. On the Device Manager tab (Windows 2000/XP: On the Hardware
tab, click Device Manager), under Other Devices, click MultiPASS
F20, then press the Delete key.
Chapter 7
click [Control Panel].
Networks" is installed. If it is not installed, click Add.
then click Add.
[Client for Microsoft Networks], then click OK.
Troubleshooting 118
6