Lcd Messages - Canon MultiPASS F30 User Manual

MultiPASS F30 User's Manual

LCD Messages

Message Message Message Message
C INK EMPTY
CARTRIDGE
JAMMED
CHECK PAPER SIZE
CHECK PRINTER
COVER OPEN
INK EMPTY
LOAD PAPER PRESS
RESUME KEY
M INK EMPTY
NOT AVAILABLE
PUT IN CARTRIDGE
WAIT COOLING
4 4 6 6
Possible Cause Possible Cause Possible Cause Possible Cause
Cyan ink tank is Replace the ink tank. See "Replacing Ink Tanks" on page 33.
empty
Printhead cannot This problem is usually due to a paper jam. Clear the paper jam or
move obstruction (see "Clearing Paper Jams" on page 22), then press
Resume Resume. Do not attempt to move the printhead manually. Resume Resume
PAPER SIZE setting Load the correct paper size or change the PAPER SIZE
different than "Changing Page Setup" on page 17.
loaded paper
Printhead not Check for any obstruction (paper clip or other small object). Also
moving check for a paper jam and clear the jam if necessary. Then press
Resume and start again. Resume Resume Resume
Waste tank is full The F30 MFP has a built-in waste ink tank to hold the ink consumed
during printhead cleaning. Contact the Canon Customer Care Center
to have the waste ink tank replaced.
Printhead is Check the printhead for signs of damage. If the printhead needs to
defective be replaced contact the Canon Customer Care Center.
Scanning unit was Close the scanning unit.
opened during
operation
Black ink tank is Replace the ink tank. See "Replacing Ink Tanks" on page 33.
empty.
No paper loaded Load paper in the multi-purpose tray. Make sure the stack is below
the paper limit mark. Press Resume
Magenta tank is Replace the ink tank. See "Replacing Ink Tanks" on page 33.
empty.
A group speed- Use regular dialing, or enter a one-touch speed dialing button or
dialing number coded speed dialing code that only has one number assigned to it.
was manually
entered
Printhead not Install the printhead.
installed
Printhead is too Wait a few moments for the F30 MFP to cool down, then resume
hot printing when the LCD message changes.
Try This Try This Try This Try This
PAPER SIZE setting. See PAPER SIZE PAPER SIZE
Resume to continue printing.
Resume Resume