Using Scangear Software - Canon MultiPASS F30 User Manual

MultiPASS F30 User's Manual
To scan from an application:
Load document
1
Open the F30 MFP document cover and place the document face down on the
platen glass.
Align the document as shown.
Acquire image
2
From your image processing application, select C C a a n n o o n n M M u u l l t t i i P P A A S S S S F F 3 3 0 0
S S c c a a n n n n e e r r as the TWAIN SOURCE if not already selected. Access the scanner
software to acquire the image.
Using ScanGear
You can also adjust these settings in, and scan directly from, the MultiPASS
Toolbar's ScanGear driver.
To enable ScanGear Software:
Click the S S e e t t t t i i n n g g s s icon
the toolbar, then click the T T o o o o l l b b a a r r
S S e e t t t t i i n n g g s s tab.
Under G G e e n n e e r r a a l l , check the box for
S S h h o o w w S S c c a a n n G G e e a a r r b b e e f f o o r r e e s s c c a a n n n n i i n n g g .
The ScanGear dialog box will open
whenever you scan from the
MultiPASS Toolbar.
3 3 0 0
Software
®
on