General Problems - Canon imageCLASS MF3110 Basic Manual

General Problems

The machine has no power.
Q Is the power cord plugged in securely?
A Check that the power cord is plugged securely into the machine and into the
wall outlet. Insert the power cord straight into the power socket on the back of
the machine. Do not insert it at an angle. Otherwise, the machine may not be
properly connected to the power source and may not turn on. If this happens,
disconnect the power cord, and reconnect it correctly after a minute or more.
(See the Set-Up Instructions.)
Nothing appears in the LCD.
Q Is the power cord plugged in securely?
A Check that the power cord is plugged securely into the machine and into the
wall outlet. Insert the power cord straight into the power socket on the back of
the machine. Do not insert it at an angle. Otherwise, the machine may not be
properly connected to the power source and may not turn on. If this happens,
disconnect the power cord, and reconnect it correctly after a minute or more.
(See the Set-Up Instructions.) If the LCD remains blank, unplug the machine
and wait approximately 3 minutes to 5 minutes until the temperature inside the
machine lowers, then plug it in again. If the LCD remains blank, unplug the
machine, and contact Canon Authorized Service Facilities or the Canon
Customer Care Center.
Q Does the Energy Saver key go off?
A When the Energy Saver key lights up, the energy saver mode activates. To
restore the machine from the energy saver mode, press [Energy Saver].
General Problems 9-19
9