Accessories - Lincoln Electric INVERTEC V145-S Service Manual

OFF OFF
The machine is turned OFF
and/or the input cord could be
disconnected from the mains.
ERROR condition: With the
Power Switch turned ON and the
input cord properly connected to
a "live" main supply, this LED
condition indicates a machine
damage.
ON ON ERROR condition: This LED
condition indicates a machine
damage.
E. Positive Quick Disconnect: Positive output
connector for the welding circuit.
F. Negative Quick Disconnect: Negative output
connector for the welding circuit.
G. Power Switch: It
turns ON / OFF
the input power to
the machine.
H. Input cable: This
machine is
provided with a
plugged input
cord. Connect it
to the mains.
I. Fan: This
machine has a
F.A.N. (Fan As
Needed) circuitry
inside: the fan is
automatically turned ON or OFF. This feature
reduces the amount of dirt which can be drawn
inside the machine and reduces power
consumption. The F.A.N. operates in different
modes, it depends by the machine type and by the
selected weld:
•
V145-S CE (STICK mode): When the machine
is turned ON the fan will turn ON. The fan will
continue to run whenever the machine is
welding. If the machine doesn't weld for more
than five minutes, the fan will turn OFF.
•
V145-S CE (TIG mode), V145-S CE (12V) and
AUSTRALIA (STICK and TIG modes): When
the machine is turned ON the fan is OFF. The

Accessories

KIT-140A-16-3M
KIT-140A-25-5M
W0400062A
W7915000A
Welding kit cables (3m, 16mm2).
Welding kit cables (5m, 25mm2).
TIG torch with tap, 4m.
.
Carrying case with accessories: Welding kit cables (3m, 16mm
Welding mask with glasses.
fan will turn ON only when a weld is started and
it will continue to run whenever the machine is
welding. If the machine doesn't weld for more
than five minutes, the fan will turn OFF.
Maintenance
For any maintenance or repair operations it is
recommended to contact the nearest technical service
center or Lincoln Electric.
performed by unauthorized service centers or personnel
will null and void the manufacturers warranty.
The frequency of the maintenance operations may vary
in accordance with the working environment. Any
noticeable damage should be reported immediately.
•
Check cables and connections integrity. Replace, if
necessary.
•
Keep clean the machine. Use a soft dry cloth to
clean the external case, especially the airflow inlet /
outlet louvers.
Do not open this machine and do not introduce anything
into its openings. Power supply must be disconnected
from the machine before each maintenance and service.
After each repair, perform proper tests to ensure safety.
9
WARNING
Maintenance or repairs
WARNING
2
), Hammer/wire brush,