Wiring - Interlogix SB Series Installation Manual

Wiring

We recommend that different power supplies are used for the module and
heating.
Note: When using guillotine connectors, put the wire in the connector, and then
pull it out slightly so that it tightens.
Figure 5: Terminals and controls
Item Description
(1) Top cell
(2) Bottom cell
(3) DIP switches
(4) Delay adjustment
(5) Selection button
(6) Alarm LED
Table 1: Terminals
Terminal Description
1 "+" Power
2 "−" Power
3 "+" Heating
6
Note
Channel selection (1 and 2)
Operating mode selection (3 to 5)
An adjustment of the response time of the intrusion alarm (50 to
800 ms)
Select alignment mode
Select cells in alignment mode
Intrusion alarm / disqualification (blinking)
Level of the signal in alignment
SB Series AIR Beam Detectors Installation Manual