Monitoring Conditional Debugging; Configuration Examples For Conditional Debugging - Cisco Catalyst 9400 System Management Configuration Manual

Monitoring Conditional Debugging

Monitoring Conditional Debugging
The table shown below lists the various commands that can be used to monitor conditional debugging.
Command
show platform condition
show debug
show platform software trace filter-binary
request platform software trace filter-binary

Configuration Examples for Conditional Debugging

The following is an output example of the show platform condition command.
Device# show platform condition
Conditional Debug Global State: Stop
Conditions Direction
----------------------------------------------------------------------------------------------|---------
MAC Address 0024.D7C7.0054 N/A
Feature Condition Type Value
-----------------------|-----------------------|--------------------------------
Device#
The following is an output example of the show debug command.
Device# show debug
IOSXE Conditional Debug Configs:
Conditional Debug Global State: Start
Conditions Direction
----------------------------------------------------------------------------------------------|---------
MAC Address 0024.D7C7.0054 N/A
Feature Condition Type Value
-----------------------|-----------------------|--------------------------------
Packet Infra debugs:
Ip Address Port
------------------------------------------------------|----------
Device#
The following is a sample of the debug platform condition stop command.
Device# debug platform condition stop
Conditional Debug Global State: Stop
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
382
Conditional Debug and Radioactive Tracing
Purpose
Displays the current conditions set.
Displays the current debug conditions set.
Displays logs merged from the latest tracefile.
Displays historical logs of merged tracefiles on the
system.