Enabling And Disabling Sequence Numbers In Log Messages; Defining The Message Severity Level - Cisco Catalyst 9400 System Management Configuration Manual

Enabling and Disabling Sequence Numbers in Log Messages

Enabling and Disabling Sequence Numbers in Log Messages
If there is more than one log message with the same time stamp, you can display messages with sequence
numbers to view these messages. By default, sequence numbers in log messages are not displayed.
This task is optional.
Procedure
Step 1
Step 2
Step 3

Defining the Message Severity Level

Limit messages displayed to the selected device by specifying the severity level of the message.
This task is optional.
Procedure
Step 1
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
266
Command or Action
Device(config)# end
Command or Action
configure terminal
Example:
Device# configure terminal
service sequence-numbers
Example:
Device(config)# service sequence-numbers
end
Example:
Device(config)# end
Command or Action
configure terminal
Example:
Device# configure terminal
Configuring System Message Logs
Purpose
Purpose
Enters global configuration mode.
Enables sequence numbers.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.