Cisco Catalyst 9400 System Management Configuration Manual page 134

Workflow for Topology: CSLU Disconnected from CSSM
4. Download All for Cisco and Upload From Cisco
Where tasks are performed: CSLU and CSSM
a. Download All For Cisco (CSLU Interface), on page 142
b. Uploading Usage Data to CSSM and Downloading an ACK, on page 159
c. Upload From Cisco (CSLU Interface), on page 143
Result:
Since the product instance initiates communication, it automatically sends out the first RUM report at the
scheduled time, as per the policy. Along with this first report, if applicable and if required, it sends a trust
code request. To know when the product instance will be sending this information, enter the show license all
command in privileged EXEC mode and in the output, check the date for field
Since CSLU is disconnected from CSSM, you must save usage data which CSLU has collected from the
product instance to a file. Then, from a workstation that is connected to Cisco, upload it to CSSM. After this,
download the ACK from CSSM. In the workstation where CSLU is installed and connected to the product
instance, upload the file to CSLU.
In case of a change in license usage, see
Tasks for CSLU-Initiated Communication
CSLU Installation → CSLU Preference Settings → Product Instance Configuration → Download All
for Cisco and Upload From Cisco
1. CSLU Installation
Where task is performed: A Windows host (laptop, destop, or a Virtual Machine (VM)
Download the file from
Refer to the
2. CSLU Preference Settings
Where tasks is performed: CSLU
a. In the CSLU Preferences tab, click the Cisco Connectivity toggle switch to off. The field switches
to "Cisco Is Not Available".
b. Configuring a Smart Account and a Virtual Account (CSLU Interface), on page 138
Adding a CSLU-Initiated Product Instance in CSLU (CSLU Interface), on page 141
c.
d. Collecting Usage Reports: CSLU Initiated, on page 141
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
116
Enter the license smart url cslu http://<cslu_ip_or_host>:8182/cslu/v1/pi command in global
configuration mode. For
<cslu_ip_or_host>
host where you have installed CSLU. 8182 is the port number and it is the only port number that
CSLU uses.
Device(config)# license smart url cslu http://192.168.0.1:8182/cslu/v1/pi
Device(config)# exit
Device# copy running-config startup-config
Configuring a License , on page 163
Smart Software Manager
Cisco Smart License Utility Quick Start Setup Guide
, enter the hostname or the IP address of the windows
Next report push:
to know how it affects reporting.
> Smart Licensing Utility.
for help with installation and set-up.
Smart Licensing Using Policy
.