Examples; What To Do Next; Copying A Configuration File From An Ftp Server To The Device - Cisco Catalyst 9400 System Management Configuration Manual

Managing Configuration Files

Examples

Copy RCP Running-Config
The following example copies a configuration file named host1-confg from the netadmin1 directory on the
remote server with an IP address of 172.16.101.101, and loads and runs the commands on the device:
device# copy rcp://netadmin1@172.16.101.101/host1-confg system:running-config
Configure using host1-confg from 172.16.101.101? [confirm]
Connected to 172.16.101.101
Loading 1112 byte file host1-confg:![OK]
device#
%SYS-5-CONFIG: Configured from host1-config by rcp from 172.16.101.101
Copy RCP Startup-Config
The following example specifies a remote username of netadmin1. Then it copies the configuration file named
host2-confg from the netadmin1 directory on the remote server with an IP address of 172.16.101.101 to the
startup configuration.
device# configure terminal
device(config)# ip rcmd remote-username netadmin1
device(config)# end
device# copy rcp: nvram:startup-config
Address of remote host [255.255.255.255]? 172.16.101.101
Name of configuration file[rtr2-confg]? host2-confg
Configure using host2-confg from 172.16.101.101?[confirm]
Connected to 172.16.101.101
Loading 1112 byte file host2-confg:![OK]
[OK]
device#
%SYS-5-CONFIG_NV:Non-volatile store configured from host2-config by rcp from 172.16.101.101

What to Do Next

After you have issued the copy EXEC command, you may be prompted for additional information or for
confirmation of the action. The prompt displayed depends on how much information you provide in the copy
command and the current setting of the file prompt global configuration command.

Copying a Configuration File from an FTP Server to the Device

To copy a configuration file from an FTP server to the running configuration or startup configuration, complete
the tasks in this section:
Procedure
Step 1
Command or Action
rcp://[user1@example.com/dir10/fileone]
nvram:startup-config
Command or Action
enable
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Purpose
Purpose
Enables privileged EXEC mode.
Examples
299