What To Do Next; Copying A Configuration File From A Tftp Server To The Device - Cisco Catalyst 9400 System Management Configuration Manual

Managing Configuration Files

What to Do Next

After you have issued the copy EXEC command, you may be prompted for additional information or for
confirmation of the action. The prompt displayed depends on how much information you provide in the copy
command and the current setting of the file prompt global configuration command.

Copying a Configuration File from a TFTP Server to the Device

To copy a configuration file from a TFTP server to the device, complete the tasks in this section:
Procedure
Step 1
Step 2
Step 3
Step 4
Examples
In the following example, the software is configured from the file named tokyo-confg at IP
address 172.16.2.155:
Device# copy tftp://172.16.2.155/tokyo-confg system:running-config
Command or Action
enable
Example:
Device> enable
copy tftp: [[[//location]/directory]/filename]
system:running-config
Example:
Device# copy
tftp://server1/dir10/datasource
system:running-config
copy tftp: [[[//location]/directory]/filename]
nvram:startup-config
Example:
Device# copy
tftp://server1/dir10/datasource
nvram:startup-config
copy tftp:
[[[//location]/directory]/filename]flash-[n]:/directory/startup-config
Example:
Device# copy
tftp://server1/dir10/datasource
flash:startup-config
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Copies a configuration file from a TFTP server
to the running configuration.
Copies a configuration file from a TFTP server
to the startup configuration.
Copies a configuration file from a TFTP server
to the startup configuration.
What to Do Next
297