Section 14-Cooling Fan; Replacing Cooling Fan - Invacare Platinum IRC5LXO2AW Service Manual

Hide thumbs Also See for Platinum IRC5LXO2AW:

Table of Contents

SECTION 14—COOLING FAN

NOTE: Refer to Recycling Information following local governing ordinances and recycling plans

regarding disposal of the concentrator or components.

To prevent electrical shock, ALWAYS disconnect concentrator from electrical

outlet before servicing.

1. Turn power Off (O) and unplug the unit.

2. Remove cabinet. Refer to Cabinet on page 25.

3. Remove control panel. Refer to Removing Control Panel on page 50.

4. Remove compressor assembly. Refer to Compressor on page 35.

5. Disconnect and remove spade connectors from fan terminals on back side of cooling

fan (not shown).

6. Remove four mounting screws securing the cooling fan to the sound box.

7. Remove existing cooling fan.

Fan MUST be positioned properly so air from the fan blows down onto the

compressor (see air flow arrow on back of fan and make sure the arrow is pointing

down) or damage to the unit will occur.

8. Install new cooling fan.

NOTE: Run the self-threading mounting screws through the fan housing holes to cut the threads

and remove them before mounting the fan for ease of installation.

9. Reinstall compressor. Refer to Compressor on page 35.

10. Reinstall control panel. Refer to Removing Control Panel on page 50 and reverse all

steps.

11. Run unit and inspect for leaks. Refer to Leak Test on page 71.

12. If no leaks detected, turn power Off (O) and unplug the unit.

13. Reinstall cabinet. Refer to Removing Cabinet on page 25.

Platinum

Oxygen

DANGER

CAUTION

Part No 1118396

Table of Contents

Platinum irc9lxo2awq