Table of Contents
Advertisement
Location and Function of Parts and Controls
Front Panel
Power indicator
Indicator
Operating State
Green
Power on
Flashes in Green
Power on with image displayed
(reduced backlight due to high
temperature)
Orange
Standby
Flashes in Orange
No image displayed (remote standby)
(On)/ (Standby) switch
Press the side to turn the monitor on. Press the
side to switch the unit to standby state.
Input select buttons
PORT A/PORT B: Each input connector can
be assigned for PORT A/B.
12G-SDI is assigned for PORT A/B in the default
setting.
When you press
PORT A or
it is lit in green, a menu for selecting the input
connector assigned to the PORT A/B is
displayed.
When you press
it is lit in white, an image from the input
connector assigned to the PORT A/B is
displayed.
Multi-image display setting buttons
display or switching the multi-image display
mode.
display and the sub display.
Press to select "Off," "On," or "Check Mode" for
the A.I.M.E. setting.
Also, you can adjust A.I.M.E. Structure, A.I.M.E.
Color, and A.I.M.E. Shadow.
CUSTOM buttons
Turns on or off the assigned function. You can
PORT B when
adjust the assigned function by pressing the /
buttons. (Refer to the Custom Button of the
System Configuration menu on page 32 and of
the Initial Setup menu on page 32.)
18
PORT A or
PIP/POP: For displaying the multi-image
SWAP: For swapping between the main
A.I.M.E. button
PORT B when
Advertisement
Table of Contents
