Table of Contents
Advertisement
LN2600 Rugged Security Router
Disabling or Enabling File System Cleanup
72
When you disable POST, the standard set of POST diagnostic tests are skipped. The
following sample console output shows that the POST feature is disabled:
....
NVMRO:
Write-enabled
watchdog:
Armed
FPGA:
Enabled
FS Cleanup:
Disabled
POST:
Disabled
Firmware Image Status:
Primary Bootstrap: UP TO DATE
....
IPMC test completed, 1 pass, 0 errors, 0 warnings
Skipping POST
Booting...
Enabling POST
To enable the POST feature and run the full set of POST diagnostic tests during the
boot-up process:
NOTE:
The POST feature's default setting is
BOOT> unsetenv no_run_post
BOOT> saveenv
BOOT> reset
or
BOOT> setenv no_run_post 0
BOOT> saveenv
BOOT> reset
When you enable POST, the full set of POST diagnostic tests run. The following sample
console output shows that the POST feature is enabled:
....
NVMRO:
Write-enabled
watchdog:
Armed
FPGA:
Enabled
FS Cleanup:
Disabled
POST:
Enabled
Firmware Image Status:
Primary Bootstrap: UP TO DATE
....
Disabling File System Cleanup
To disable the file system cleanup feature:
.
enabled
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
