Stopping The Unit - Brakes - New Holland Workmaster 25S Operator's Manual

4 - OPERATING INSTRUCTIONS

Stopping the unit - Brakes

In normal operating conditions to stop the unit simply remove your foot from the forward or reverse Hydrostatic Trans-
mission (HST) travel pedals See page 3-8 for HST pedal information. If you are going down an incline or pulling
a heavy load it may be necessary to apply the service brake. To apply the service brakes press down on the brake
pedal on the left-hand side of the operator's platform. The single brake pedal will apply the brakes to both the left-hand
and right-hand rear wheels. See page 3-8 for service brake information. If four wheel braking is desired engage the
Four-Wheel Drive (4WD). See page 3-8 for 4WD information.
4-10