Steps
1. Align and place the touchpad module into the slot on the palmrest assembly.
2. Install the two (M2x2) screws to secure the touchpad module to the palmrest assembly.
3. Align and place the touchpad bracket on the touchpad module.
4. Install the three (M2x2) screws to secure the touchpad bracket to the touchpad module.
5. Connect the touchpad cable to the connector on the system board and close the latch.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Install the microSD-card.
4. Follow the procedure in
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Enter the
service
mode.
4. Remove the
base
cover.
5. Remove the
display
assembly.
6. Remove the
input output
7. Remove the
heatsink
About this task
The following image indicates the location of the power-button board and provides a visual representation of the removal
procedure.
48
Removing and installing components
after working inside your
before working inside your
board.
assembly.
computer.
computer.