Table of Contents
Advertisement
Steps
1. Align and place the type-c bracket on the system board.
NOTE:
The type-c bracket must be installed on the system board before installing the system board into the palmrest
assembly. Technicians cannot install the Type-c bracket once the system board is assembled into the palmrest assembly.
2. Align and place the system board on the chassis.
3. Install the (M2x3) screw to secure the type-c bracket in place.
4. Install the (M2x2.5) screw to secure the system board in place.
5. Connect the input output board cable to the connector on the system board and close the latch.
6. Connect the power cable, power button with finger print reader cable, speaker cable, and coin-cell battery cable to the
connectors on the system board.
7. Connect the touchpad cable, keyboard cable, and LED cable to the connectors on the system board and close the latch.
Next steps
1. Install the
power button with fingerprint
2. Install the
heatsink
assembly.
3. Install the
input output
4. Install the
display
assembly.
5. Install the
system
fan.
6. Install the
M.2 solid-state
7. Install the speakers.
8. Install the
base
cover.
9. Exit the
service
mode.
10. Install the microSD-card.
11. Follow the procedure in
reader.
board.
drive.
after working inside your
computer.
Removing and installing components
55
Advertisement
Table of Contents
