Place Of Installation - Riello RBS 1S Series Installation, Operation And Maintenance Manual

INSTALLATION
INSTALLATION
Proceed as follows to remove the storage cylinder from the pallet:
− Place a platform of about half the height of the pallet near
the storage cylinder. Make sure the platform is able to sup-
port the weight of the storage cylinder.
− Remove the pallet fastening brackets
− Carefully rotate and slide the storage cylinder until it rests
on the platform
− Make sure that the storage cylinder is perfectly stable, and
then remove the pallet
− Carefully rotate and slide the storage cylinder off the plat-
form on to the floor
− Remove the platform. Position the storage cylinder as re-
quired.
Adjust the feet to ensure that the storage cylinder is perfectly level.

9 PLACE OF INSTALLATION

R RBS 1S storage cylinders can be installed in any room where
there is no specific requirement for an electrical protection rating
higher than IP X0D.
Z
DESCRIPTION
X
Y
Z
NOTE: the above-indicated dimensions are recommended for a
correct maintenance and access to the device.
9.1 Installation in older systems and systems
requiring modifications
When the
that need modernising, make sure that:
− Make sure that the system is fitted with safety and con-
17
− Make sure that the central heating circuit has been flushed
− There is a treatment system used when the delivery/supply
10
RBS 1S
≥ 300
≥ 11 13/16
≥ 600
≥ 23 5/8
≥ 700
≥ 27 9/16
R RBS 1S appliance is installed on old systems or ones
trol devices in accordance with applicable legislation and
standards
out to remove all sludge and lime scale, and has been
vented and seal tested
water is considered special (reference values can be taken
from the table in the section "Water quality requirements").
mm
inch
mm
inch
mm
inch