Table of Contents
Advertisement
INSTALLATION
The unit is provided with two handles (1) for manual handling.
Handles are supplied with the unit, not installed: where
necessary, they must be fastened with two screws M8 each,
already screwed in the threaded inserts.
1
9
A minimum of two persons are required to carry out manual
handling operations.
2 . 1 .4 Storage
In case of long term storage keep the unit protected from dust,
and away from sources of vibration and heat.
Storage temperatures must be within -20°C and +60°C.
9
R
declines all liability for damage due to bad unloading
or non-protection from atmospheric agents.
0
STORING the unit filled with water is forbidden.
9
Do not place tools or weights on the packaged unit.
2 . 1 .5 Material supplied with the unit
The unit is supplied with a document envelope, containing the
following material:
− Instruction booklet for the installer and the Technical
Support Service (languages: Italian, English, French,
German and Dutch)
− The warranty/spare parts labels
− Declaration of conformity
− Contact sheet
− Handles for handling.
2 .2 Safety standards
R
declines all responsibility for the failure to comply with the
Safety and Accident-prevention Standards described below.
It also declines all liability for damage caused by improper use
of the NexPro Plus unit and/or modifications performed without
authorisation.
− Specialised staff must perform installation.
− Wear suitable and accident-prevention clothing during
installation, for example: goggles, gloves etc. as indicated
in the standard 686/89/EEC and subsequent amendments
− During installation operate in complete safety, clean
environment and free from obstructions.
− Comply with all applicable laws in force in the country
where the machine is installed, as regards the use and
disposal of the products used for machine cleaning, and
follow the recommendations contained in this booklet.
− Before starting the unit, check the perfect integrity of the
various components of the entire plant.
− Do not touch moving parts or intervene between these.
9
The installer must consider and remedy all the other types of
risks related to the system. For example, risks deriving from
the entry of foreign bodies or risks due to the conveying of
dangerous inflammable or toxic gases at a high temperature.
2 .3 Choice of installation place
9
1
Do not place the unit in rooms containing vapours, dust,
flammable gases, acid, aggressive and corrosive substances
that may irreparably damage the various components.
9
Do not install the unit in an environment that can reach
conditions conducive to ice formation.
9
Do not install the unit outdoors. In such a case performance
and safety of the product are not guaranteed.
− Place the unit on a flat surface capable of supporting the
weight of the product and its contents.
− Check that the installation room, if the unit is used without
exhaust air duct, has a suitable volume, with a suitable
air circulation. Note that the outlet air temperature is
5-10 ° C lower than the inlet, therefore, if not ducted,
running the unit can cause a sensible reduction of the
temperature of installation room.
− Verify that installation environment, electrical and
plumbing, to which the unit will be connected, comply
with regulations.
− The intake air must not contain dust.
− Leave a minimum clearance as shown in the figure, in
order to make possible the installation and ordinary and
extraordinary maintenance.
8
min. 0,5 m
min. 0,5 m
Advertisement
Table of Contents
